Homa GRP TP Motor Voltage Change Bedienungsanleitung PDF herunterladen

Publication

88FN2045A

Please Contact

Technical Support At 203

736

8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 5

GRP, TP Motor Voltage Change

This procedure will provide you with step by step instructions to

convert 208/230 V operating voltage to 460V in dual voltage motors.

1. Remove pump from service. Disconnect

power supply. Clean and decontaminate

pump prior to working on it. See the

pump Installation, Operation, and

Maintenance Manual for detailed

instructions.

2. With pump in stable, upright position,

remove the 5mm cap screws as

indicated.

3. Carefully lift stator housing 3 inches with

hoist, if available, and check under stator

housing for internal seal probe.

CAREFUL: lifting housing more than 3

inches may damage seal probe. If no

hoist is available, lift by hand and slide

the 2x4s under the housing to hold it up.

Disconnect probe if installed. Carefully lift

stator housing off the pump.

You Need:

5mm Allen Wrench

Wire Cutters

Wire Strippers

Terminal Crimp Tool

Qty 6-Crimpable Wire Nut

Hoist or Qty 2-2x4s

1 2 3 4 5